What does it cost when a Viking leaks water inside?
Water collecting inside a Viking usually comes from the defrost side, a $290–$650 job with Viking Repair Kirkland, and the $89 visit that finds it is taken off that bill. Water creeping out from underneath is a supply-line fault, priced once it is traced. Call (425) 629-0033 and say where the water sits.
- Refrigeration fan or defrost system
- $290–$650
- Water line, filter housing or inlet valve
- Quoted after the diagnosis
- Service call and diagnosis, credited if you go ahead
- $89
Before you call
3 checks for this job
-
1Where is the water: on the shelves and under the crisper drawers, or on the floor in front?
No call yet A spilled container, or drops after the door stood open, is not a fault. Dry it and look tomorrow.
Call Water that returns inside the cabinet, or ice on the compartment floor, points at the defrost drain.
-
2Did the puddle appear right after a new water filter went in?
No call yet Refit the cartridge as your use and care guide shows, turning it until it locks.
Call If it still drips with the cartridge locked in, the housing or its line needs a look.
-
3Is water spreading across the floor from under the unit?
No call yet Beads along the base on a very humid day can be condensation. Wipe them and check both doors close fully.
Call Water that keeps coming is the supply side. Close the valve that feeds the ice maker, put towels down and ring. Viking Repair Kirkland answers on (425) 629-0033.
What moves the price?
| Factor | What it does to the quote |
|---|---|
| Which side the water comes from | A frozen or clogged defrost drain sits in the fan-and-defrost band; a line, filter housing or inlet valve is priced once traced. |
| Why the drain froze | A failed defrost heater, or the sensor that ends the melt, is replaced along with clearing the drain. |
| Ice that has to go first | A drain buried in ice is thawed before it can be cleared and tested, and that time is labour. |
Why does water end up inside the cabinet?
A frost-free Viking melts the frost off its evaporator (the coil that makes the cold) every so often. The melt runs down a drain to a pan at the base of the unit, where it evaporates. If that drain freezes or clogs, the water spills onto the compartment floor or turns to ice in the freezer.
Why does clearing the drain alone not hold?
Something upstream froze it: a defrost heater that has weakened, a sensor that ends the melt too early, or a tired seal letting damp air frost the coil faster. Clear the ice without fixing that and the drain closes again.
What should you do until the visit?
Lay towels, empty any drawer standing in water and keep the doors shut. Viking warns against speeding a defrost with tools, and its manual for one undercounter model cautions that a heavily iced coil melting all at once can overwhelm the defrost drain.
What did Kirkland owners say once it was fixed?
5.0 / 51,449 ratings
The second unit in the garage warmed up whenever the weather did. He explained the ambient limit honestly instead of selling me parts, then replaced a torn door gasket while he was here.
Harriet W.
Frost built up on the back wall of the pantry unit every week. The defrost heater tested open at the connector. Replaced, then he stayed to watch a full cycle through before packing up.
Silas M.
Water kept pooling under the crisper drawers and freezing into a sheet. It was a plugged drain line, not the sealed system somebody else had hinted at. Cleared, and he showed me the tray.
Fiona D.
Want a firm figure for your Viking?
$89 for the visit and the diagnosis, taken off the repair if you go ahead. Technicians out 8am–8pm, every day; the line is answered 24/7.