Is your Viking oven running cold, slow or uneven?
Viking wall ovens and range ovens: temperatures that drift, preheats that drag, elements that glow in patches, convection faults and doors that no longer close tight.
What does it look like when you call?
- The dial says 350 but a thermometer on the middle rack shows far less
- Preheat takes an age, and the ready signal sounds before the oven is really hot
- The broil element glows at one end and stays dark at the other
- The door has dropped on its hinges and no longer sits flat against the frame
What happens on the $89 visit?
- Cavity temperature measured with an independent probe and compared with the setting
- Bake and broil elements tested for continuity and watched for an even glow
- Oven sensor (the probe that tells the control how hot it is) measured cold, then hot
- Hinges, springs and the door gasket checked, since a door that leaks heat looks like a control fault
Parts are ordered against your model and serial number, so the part that goes in is the one the unit was built with. If the repair does not make sense for the unit in front of you, you hear that before any money is spent beyond the $89.
Visits 8am–8pm, every day; the phone is answered 24/7.
What does Viking oven repair cost in Kirkland?
A flat $89 call-out pays for the trip and the whole diagnosis; say yes to the repair and that $89 comes off its price.
Each line is a range, because the exact figure depends on the part your model takes. The technician reads the fault first; you get one written number before anything is dismantled.
- Refrigeration fan or defrost system
- $290–$650
- Compressor or sealed-system repair
- $1,420–$3,330
- Control board or touch panel
- $450–$690
- Dishwasher pump or control
- $210–$430
- Igniter or burner assembly
- $170–$460
- Oven thermostat or heating element
- $210–$470
What did Kirkland owners say once it was fixed?
5.0 / 51,372 ratings
It read 350 and a probe on the middle rack said closer to 310. The sensor was drifting and the calibration had never been set after the install. Cakes behave again for the first time in two years.
Camille T.
Oven quit halfway through a roast and threw a code we could not find anywhere. The bake element had failed open where it passes through the back. In and out inside the hour, dinner saved.
Wynn P.
Broil element glowed at one end and stayed dark at the other. Replaced on the first visit and it works properly now. The window slipped by a couple of hours, though someone rang to tell me.
Leif M.
Ready to have it looked at?
Give the model number and one sentence on what it is doing. The visit is $89 for the trip and the diagnosis, and it is taken off the repair when you approve the work.
Visits 8am–8pm, every day · phone answered 24/7
