Is your Viking refrigerator or freezer failing in Kirkland?
Built-in, column and freestanding Viking refrigeration: warm compartments, freezers that stop freezing, water inside the cabinet, units that never switch off, and ice makers that quit.
What does it look like when you call?
- The fresh-food side reads in the fifties while the freezer beside it stays hard
- A sheet of ice has formed under the crisper drawers and keeps coming back
- It runs without a break and the air from the grille feels warmer than it should
- The ice bin fills with small, hollow cubes, or nothing at all
What happens on the $89 visit?
- Both compartments logged with a probe thermometer over a cycle, not read once off the display
- Evaporator fan (the fan that moves cold air from the coil into the compartment) tested at its plug
- Defrost heater, defrost thermostat and drain path checked for the ice that blocks airflow
- Condenser airflow and the door seal ruled in or out before the sealed system is discussed
Which job is it?
Most warm Vikings turn out to need a fan or a defrost part, not a compressor. The symptom points at the job; the measurement on the visit confirms it before Viking Repair Kirkland quotes a figure.
| What you notice | Likely job | Band |
|---|---|---|
| Fresh-food side warm, freezer still frozen | Evaporator fan or defrost fault | $290–$650 |
| Ice building up behind a panel, water under the drawers | Defrost heater, thermostat or blocked drain | $290–$650 |
| Display blank, erratic readings, nothing responds | Control board or touch panel | $450–$690 |
| Runs all the time, both sides warming, fans turning | Compressor or a refrigerant leak — confirmed before it is quoted | $1,420–$3,330 |
Built-in, column and undercounter units share these parts in principle but not in price: the model decides which fan, board or heater fits. Each of those jobs has its own page on the cost index.
See every Viking repair priced on its own page
Visits 8am–8pm, every day; the phone is answered 24/7.
What does Viking refrigerator repair cost in Kirkland?
A flat $89 call-out pays for the trip and the whole diagnosis; say yes to the repair and that $89 comes off its price.
Each line is a range, because the exact figure depends on the part your model takes. The technician reads the fault first; you get one written number before anything is dismantled.
- Refrigeration fan or defrost system
- $290–$650
- Compressor or sealed-system repair
- $1,420–$3,330
- Control board or touch panel
- $450–$690
- Dishwasher pump or control
- $210–$430
- Igniter or burner assembly
- $170–$460
- Oven thermostat or heating element
- $210–$470
What did Kirkland owners say once it was fixed?
5.0 / 51,192 ratings
Ice maker filled but dropped small hollow cubes that stuck together in the bin. The fill valve was weak and the water line had a kink from the original install. Cubes are solid again.
Thea K.
Compressor ran constantly and the floor in front was warm. The condenser was packed with dust from the building work next door. Cleaned out, and it is quiet again.
Nils A.
Frost built up on the back wall of the pantry unit every week. The defrost heater tested open at the connector. Replaced, then he stayed to watch a full cycle through before packing up.
Silas M.
Ready to have it looked at?
Give the model number and one sentence on what it is doing. The visit is $89 for the trip and the diagnosis, and it is taken off the repair when you approve the work.
Visits 8am–8pm, every day · phone answered 24/7
